Support

90% of our users say that a quick search solved their problem!

How do I exit 'Valet Mode'?

You will know if you have accessed the Valet Mode feature, if you receive 3 parking light flashes followed by 10 parking light flashes upon the remote start command. With LCD remotes, you will get an error 10.

NOTE: If your LCD screen reads 'Hold' also, please follow this link to exit the button hold first - Exit Hold Mode

To exit 'Valet Mode' -

4 or 1 BUTTON REMOTES:

Please click on the link for a step-by-step guide on how to re-program your remote. 9 out 10 times this will clear the issue - Program Remote

If you are unsuccessful, you may try the steps below:

4 BUTTON REMOTE ONLY:

  • Turn key to the 'ON/RUN'
  • Press and release the lock button and the trunk button simultaneously (buttons I & III). Note: Holding the buttons for over .5 seconds will cause this to fail.
  • You will receive two parking light flashes to inform you that this was successful.    

1 BUTTON REMOTE ONLY:

  • Simply turn the key to the ‘ON/RUN’ position and press the foot brake down 10 times within 10 seconds.

 EDGE 2X REMOTE:

  • Turn key to the 'ON/RUN'
  • Press and release the function button and the trunk button simultaneously. Note: Holding the buttons for over .5 seconds will cause this to fail.
  • You will receive two parking light flashes to inform you that this was successful. 

If you do not have a remote, then the following can be attempted:

  • Start the vehicle
  • Press and release the foot brake pedal 10 times within 10 seconds.
  • This procedure will only deactivate Valet Mode, it will not activate Valet Mode. The vehicles parking lights should flash twice to indicate the system has exited valet mode.

If you are unable to exit after attempting the steps above, please visit your Local Dealer or original installer of the product for assistance.

 

Thank you.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request
Please sign in to leave a comment.

0 Comments